York PIR Sensor – Outdoor Lantern Wall Light 240v – 304 Stainless Steel IP44 E27

     
York – 240v – 304 Stainless Steel IP44 E27 Max 60w Wall Light With PIR Motion Sensor

The York is a Modern take on the old style garden coach house lantern amenity light. Very minimalist design with clear glass lens to maximise light output. The York outdoor garden range offers a modern interpretation on a traditional design.
Its 304 polished stainless steel construction gives a contemporary twist to the entire
range. Complete with integral PIR sensor. A welcome focal point for anyone approaching a house as well as a pathway or doorway entrance light that is activated by movement. There is also a non sensor York light fitting to match this item. Code 4478182.

Lamp Colour (Kelvins) 

The colour of a lamp is defined as a measurement called kelvins. A standard GLS incandescent bulb in the home would
be 2,700 kelvins which is in the warm colour spectrum and a lamp with 5,000 kelvins would be at the very cold
white spectrum. 

Installation – See attached Instructions & Data Sheet


Choosing the style of a product is only part of the equation you must also think of where that product will be used and
how it will be installed. All exterior lighting products on our web site have an IP rating appropriate to each light
fitting and its intended application and is therefore fit for purpose. Water ingress is the enemy for outdoor lighting
and the products supplied are only as good as the installation. The weakest point is always cable joints. All joints
must be made 100% watertight and this can be done using IP68 cable connectors and/or waterproof junction boxes which
are then filled with a re-enterable liquid gel mix. All joints where possible should be made above ground for easy
access and reduced water ingress. When installing ground buried lights adequate drainage systems should be put in
place especially in clay-based soil areas. If possible, use ground surface spike lights rather than a buried light. 
Mains 240v cable will have less joints than a low voltage installation but care must be taken with the cable runs.
Cabling should be Rubber Butyl and not PVC. PVC leads to capillary action over time especially with UV degradation.

All exterior lights must be installed by a certified NIC EIC electrician and should be signed off by an electrician with
Part P certification. There are a selection of waterproof jointing kits and boxes available on this web site.