Spike12 Black 24vDC 12w 2700k 1250 Lumens IP67 40 Degree Beam Angle Spotlight Available In Anthracite

Spike12 garden spotlight low voltage 24v – 12w -1250lm. 40° beam angle. 2700K  warm white colour temperature. IP67 outdoor
LED spotlight constructed from diecast aluminium with an anodised black finish.
Also available in an anthracite finish code EP41240. 

The Spike12 LED spike spotlight with its modern yet discreet anodised finish make it a suitable fitting for both modern and
traditional garden settings.  Extra glare protection is available with the use of the EPGS65 glare shield. 
Powered from a 24v power supply, it makes the Spike12 LED spike spotlight a safe option, while making it more flexible
than 240v fitting when the lights need to be relocated due to the changes in the garden caused by seasonal fluctuation. 
By removing the spike from the fitting, it can be mounted onto a pergola and used for spotlighting down on to a subject.

length of body 115mm x 60mm diameter.

1.5m of 2 core cable fitted for connection to a power supply or to a cable from a transformer using T9962 cable joint kits
or T9963 cable splice kits.

3 Year warranty with the following exclusions: Damage by machinery, animals or the use of incorrect cleaning materials. Damage
due to incorrect installation practices. Responsibility for 3rd party cost: indirect or consequential loss.

12v Installation See –  Instructions & Data Sheets Tab

All exterior lighting products on our website have an IP rating which is explained further in our design ideas section
but in simple terms the IP rating is appropriate to each light fitting and its intended application and is therefore
fit for purpose. Water ingress is the enemy for outdoor lighting and the products supplied are only as good as the
installation as the weakest point is always cable joints. All joints must be made 100% water tight and this can be
done using IP68 inline connectors, waterproof junction boxes which are then filled with a resin or gel mix. All joints
where possible should be made above ground for easy access and reduced water ingress. When installing ground buried
lights adequate drainage systems should be put in place especially in clay based soil areas. 

Lamp Colour (Kelvins) 

The colour of a lamp is defined as a measurement called kelvins. A standard GLS light bulb in your house would be 2,700
kelvins which is in the warm colour spectrum and a lamp with 5,000 kelvins would be at the very cold white spectrum.