Spike12 Anthracite 24vDC 12w 2700k 1250 Lumens IP67 40 Degree Beam Angle Spotlight Available In Black

Spike12 garden spotlight low voltage 24v – 12w -1250lm. 40° beam angle. 2700K  warm white colour temperature. IP67 outdoor LED spotlight constructed from diecast aluminium
with an anodised anthracite finish.
Also available in Black code EP41240B.

The Spike12 LED spike spotlight with its modern yet discreet anodised finish make it a suitable fitting for both modern and
traditional garden settings.  Extra glare protection is available with the use of the EPGS65 glare shield.  Powered
from a 24v power supply, it makes the Spike12 LED spike spotlight a safe option, while making it more flexible than 240v
fitting when the lights need to be relocated due to the changes in the garden caused by seasonal fluctuation.  By removing
the spike from the fitting, it can be mounted onto a pergola and used for spotlighting down on to a subject.

RAL Colour code for the Anthracite finish is 7016.

length of body 115mm x 60mm diameter.

1.5m of 2 core cable fitted for connection to a power supply or to a cable from a transformer using T9962 cable joint kits or T9963 cable splice kits.

3 Year warranty with the following exclusions: Damage by machinery, animals or the use of incorrect cleaning materials. Damage due to incorrect installation practices. Responsibility for 3rd party cost: indirect or consequential loss.

12v Installation See Instructions & Data Sheets Tab

All exterior lighting products on our website have an IP rating which is explained further in our design ideas section but
in simple terms the IP rating is appropriate to each light fitting and its intended application and is therefore fit
for purpose. Water ingress is the enemy for outdoor lighting and the products supplied are only as good as the installation
as the weakest point is always cable joints. All joints must be made 100% water tight and this can be done using IP68
inline connectors, waterproof junction boxes which are then filled with a resin or gel mix. All joints where possible
should be made above ground for easy access and reduced water ingress. When installing ground buried lights adequate
drainage systems should be put in place especially in clay based soil areas. 

Lamp Colour (Kelvins) 

The colour of a lamp is defined as a measurement called kelvins. A standard GLS light bulb in your house would be 2,700 kelvins
which is in the warm colour spectrum and a lamp with 5,000 kelvins would be at the very cold white spectrum.