Slatlite 240V Garden Step Light – IP54 Solid Brass With Aged Silver Finish

This solid brass slatted step light with aged silver finish is a smart 240v surface mount garden light, ideal for
lighting stepped areas. It can be mounted on walls next to steps, or on the steps themselves. The louvered design creates
a more subtle light than a full spotlight, shining the light downwards at an angle. A mirrored reflector and frosted
glass lens inside diffuse the light outwards evenly and without glare.

The Slatlite is both robust and stylish, with a high IP rating of IP54, and has 3 external screws; to firmly secure the front
to the back. This step light has a G9 fitting. An LED G9 capsule is recommended, and is available as an optional extra.
The bright 240 volt LED G9 in daylight white or warm white (sold separately) saves more energy and has a much longer
life span than a standard halogen.

PLEASE NOTE:

WE RECOMMEND SELECTING THE LED G9 BULBS AS STANDARD FROM THE BOTTOM OF THE PAGE AS OTHER G9 BULBS MAY BE TOO LONG FOR THIS FITTING.

Lamp Colour (Kelvins) 

Choosing the style of a product is only part of the equation you must also think of where that product will be used and how
it will be installed. All exterior lighting products on our web site have an IP rating appropriate to each light fitting
and its intended application and is therefore fit for purpose. Water ingress is the enemy for outdoor lighting and the
products supplied are only as good as the installation. The weakest point is always cable joints. All joints must be
made 100% watertight and this can be done using IP68 cable connectors and/or waterproof junction boxes which are then
filled with a re-enterable liquid gel mix. All joints where possible should be made above ground for easy access and
reduced water ingress. When installing ground buried lights adequate drainage systems should be put in place especially
in clay-based soil areas. If possible, use ground surface spike lights rather than a buried light.  Mains 240v cable
will have less joints than a low voltage installation but care must be taken with the cable runs. Cabling should be Rubber
Butyl and not PVC. PVC leads to capillary action over time especially with UV degradation.

All exterior lights must be installed by a certified NIC EIC electrician and should be signed off by an electrician with
Part P certification. There are a selection of waterproof jointing kits and boxes available on this web site.