Severus Landscape Indirect IP65 2W Warm White Wall – Grey ABS Plastic – 220 – 240v

Severus landscape indirect IP65 2W warm white wall – Grey ABS Plastic – 220 – 240v

The Severus is a range of surface mounted LED guide lights which are quick and easy to fit. Manufactured from polycarbonate,
they are not suitable for coastal locations. Available in a choice of direct (downward) and indirect (upward) light, design and finish.

NOT SUITABLE FOR A MARINE ENVIRONMENT AND BY THE COAST

• The clever design means that you can now fit guide lights when you are not able to cut holes in your wall. The slim profile
  and integrated driver allows us to keep the projection from the wall to a minimum and the IP rating is ensured by
  the gasket and the diffuser when it is fitted into place. The outer cover simply clips into place to complete the
  installation
• Complete with fixing accessories
• Grey abs plastic & clear pc
• Constructed from abs plastic & polycarbonate
• Complete with integrated control gear
• 2W LED module (SMD 3014) Warm White (Included)
• K: 3000 Lm: 65 Lm/W: 33
• IP65
• Proj: 27mm H: 80mm W: 230mm
• Class 2
• 2 Years Warranty
• Weight: 0.2kg

Lamp colour ( Kelvins )

Choosing the style of a product is only part of the equation you must also think of where that product will be used and how
it will be installed. All exterior lighting products on our web site have an IP rating appropriate to each light fitting
and its intended application and is therefore fit for purpose. Water ingress is the enemy for outdoor lighting and the
products supplied are only as good as the installation. The weakest point is always cable joints. All joints must be
made 100% watertight and this can be done using IP68 cable connectors and/or waterproof junction boxes which are then
filled with a re-enterable liquid gel mix. All joints where possible should be made above ground for easy access and
reduced water ingress. When installing ground buried lights adequate drainage systems should be put in place especially
in clay-based soil areas. If possible, use ground surface spike lights rather than a buried light.  Mains 240v cable
will have less joints than a low voltage installation but care must be taken with the cable runs. Cabling should be Rubber
Butyl and not PVC. PVC leads to capillary action over time especially with UV degradation.

All exterior lights must be installed by a certified NIC EIC electrician and should be signed off by an electrician with
Part P certification. There are a selection of waterproof jointing kits and boxes available on this web site.