Seran Plain – Outdoor Wall Light 240v – Matt Black Textured Polycarbonate IP65 12w 6000k Amenity Light

Seran Plain – 240v – Matt Black Textured Polycarbonate IP65 12w 6000k 1000 Lumens Amenity Light – Wall Light

The Seran is a polycarbonate LED circular bulkhead. Its flush design makes it suitable for both walls and ceilings, offering
a robust, low energy option suitable for both commercial and domestic use. Other options available in the range..

• Matt black textured & opal pc
• Constructed from polycarbonate
• Complete with LED driver
• 12W LED module (SMD 5630) Daylight White (Included)
• K: 6000 Lm: 1000 Lm/W:83
• IP65
• Proj: 90mm Dia: 300mm
• Class 2
• IK08
• 2+3YR Extended Warranty
• Weight: 0.57 Kg

                                                                 Installation 220 – 240v

Choosing the style of a product is only part of the equation you must also think of where that product will be used and how it will be installed. All exterior lighting products on our web site have an IP rating appropriate to each light fitting and its intended application and is therefore fit for purpose. Water ingress is the enemy for outdoor lighting and the products supplied are only as good as the installation. The weakest point is always cable joints. All joints must be made 100% watertight and this can be done using IP68 cable connectors and/or waterproof junction boxes which are then filled with a re-enterable liquid gel mix. All joints where possible should be made above ground for easy access and reduced water ingress. When installing ground buried lights adequate drainage systems should be put in place especially in clay-based soil areas. If possible, use ground surface spike lights rather than a buried light.  Mains 240v cable will have less joints than a low voltage installation but care must be taken with the cable runs. Cabling should be Rubber Butyl and not PVC. PVC leads to capillary action over time especially with UV degradation.

All exterior lights must be installed by a certified NIC EIC electrician and should be signed off by an electrician with Part P certification. There are a selection of waterproof jointing kits and boxes available on this web site.