Nautilus Green Coloured Mains GU10 Max Wattage 11w, 240v IP65 Spike Light
Ground spike lights are the most popular and flexible light fittings we sell and can be used for numerous areas to
illuminate small trees and shrubs as well as garden ornaments and water features. The spike can also be removed
and the attached bracket can be used to wall mount the spot light which can be directed at an eating area or BBQ.
You could fix them on the underside of the top of a pergola and send a pencil beam of light down to the floor to
illuminate the pathway below or back light a bench area, the possibilities are endless and they are a very easy and
cost effective solution to illuminate an outdoor space.
This fitting should be used with ECO friendly LED GU10 lamps.
LED lamps offer energy savings over the traditional halogen GU10 lamps and are also cool to touch and safe around
children. Warm white and cool white are available and the cool white works well when illuminating shrubs and trees
whereas the warm white works better on brickwork and wood.
Lamp Colour (Kelvins)
2,700 kelvins which is in the warm colour spectrum and a lamp with 5,000 kelvins would be at the very cold white
spectrum.
Installation 220 – 240v – See Instructions & Data Sheets Tab=”center”>
All exterior lighting products on our website have an IP rating which is explained further in our Technical
Help/Products section but in simple terms the IP rating is appropriate to each light fitting and its intended
application and is therefore fit for purpose. Water ingress is the enemy for outdoor lighting and the products
supplied are only as good as the installation as the weakest point is always cable joints. All joints must be
made 100% water tight and this can be done using IP68 inline connectors, waterproof junction boxes which are
then filled with a resin or gel mix. All joints where possible should be made above ground for easy access and
reduced water ingress. When installing ground buried lights adequate drainage systems should be put in place especially in clay based soil areas.
All exterior lights must be installed by a certified NIC EIC electrician and should be signed off by an electrician
with Part P certification. There are a selection of waterproof jointing kits and boxes available on this
web site.
=”center”>
























Reviews
There are no reviews yet.