Myra, Aluminium Grey Finish IP44 240v GU10 Adjustable Twin Lamp Head, Surface Mounted Or Spike Spotlight

The Myra is a group of light fittings Developed and sent from Germany. The group includes a single spot wall lamps and up / down wall lights, this enables you to have a consistent theme to your outdoor lighting. SEE BASE AND SPIKE OPTIONS AT BOTTOM OF PAGE. 

The Myra twin head adjustable light fitting is a multi purpose exterior luminaire. Finished in silver grey with a slim shaft and offset adjustable mains GU10 lamps it can have a bottom section that is spiked to place it in soft grass areas or the bottom section can be a surface mounted base plate to bolt directly to a level concrete area. Each lamp head can be rotated and aimed at specific areas like a seating area and a walkway. The mains GU10 LED lamp is cool to touch and safe around children.  Connection lead length 3m.

Also available in an anthracite finish code 233185.

All exterior lighting must be installed by a NIC EIC certified electrical contractor that has experience of exterior lighting installations. All joint need to be 100% watertight by using a heat shrink cable joint kit and waterproof junction boxes. 

Lamp Colour (Kelvins) 

Choosing the style of a product is only part of the equation you must also think of where that product will be used and how
it will be installed. All exterior lighting products on our web site have an IP rating appropriate to each light fitting
and its intended application and is therefore fit for purpose. Water ingress is the enemy for outdoor lighting and the
products supplied are only as good as the installation. The weakest point is always cable joints. All joints must be
made 100% watertight and this can be done using IP68 cable connectors and/or waterproof junction boxes which are then
filled with a re-enterable liquid gel mix. All joints where possible should be made above ground for easy access and
reduced water ingress. When installing ground buried lights adequate drainage systems should be put in place especially
in clay-based soil areas. If possible, use ground surface spike lights rather than a buried light.  Mains 240v cable
will have less joints than a low voltage installation but care must be taken with the cable runs. Cabling should be Rubber
Butyl and not PVC. PVC leads to capillary action over time especially with UV degradation.

All exterior lights must be installed by a certified NIC EIC electrician and should be signed off by an electrician with
Part P certification. There are a selection of waterproof jointing kits and available on this site.