MONOLITE STEP LIGHTS BRASS (RUSTIC BRONZE) 240v
Solid Brass Monolite Outdoor Step Lights are smart surface mount garden lights with a rustic bronze finish. They’re
ideal for low-level lighting either mounted on walls next to steps, or on the steps themselves. In fact these versatile
outdoor step lights will mount onto any flat surface such as sleepers or raised beds.
As solid weatherproof units, the Monolite step lights have a single cut-out that emits a slim arc of light. This design results
in all light shining evenly downwards, without glare. A mirrored reflector inside the enhances this light. The Monolite
step lights have a front and back part that fit together securely. Once the back plate and bulb are in place, the front
part simply ‘slots’ into place.
Use the bright 2w LED G9 bulbs in cool white, or warm white save more energy and have a longer life span than standard halogen
G9s.
Lamp colour ( Kelvins )
The colour of a lamp is defined as a measurement called kelvins. A standard GLS incandescent bulb in the home would
be 2,700 kelvins which is in the warm colour spectrum and a lamp with 5,000 kelvins would be at the very cold
white spectrum.
Installation 220 – 240v
Choosing the style of a product is only part of the equation you must also think of where that product will be used and
how it will be installed. All exterior lighting products on our web site have an IP rating appropriate to each light
fitting and its intended application and is therefore fit for purpose. Water ingress is the enemy for outdoor lighting
and the products supplied are only as good as the installation. The weakest point is always cable joints. All joints
must be made 100% watertight and this can be done using IP68 cable connectors and/or waterproof junction boxes which
are then filled with a re-enterable liquid gel mix. All joints where possible should be made above ground for easy
access and reduced water ingress. When installing ground buried lights adequate drainage systems should be put in
place especially in clay-based soil areas. If possible, use ground surface spike lights rather than a buried light.
Mains 240v cable will have less joints than a low voltage installation but care must be taken with the cable runs.
Cabling should be Rubber Butyl and not PVC. PVC leads to capillary action over time especially with UV degradation.
All exterior lights must be installed by a certified NIC EIC electrician and should be signed off by an electrician with
Part P certification. There are a selection of waterproof jointing kits and boxes available on this web site.





























Reviews
There are no reviews yet.