Modula Recessed Uplight – Green – Round – 12v MR16 – 30 degree tilt
by an “O” ring on the body into a sleeve tube. To facilitate removal of screws for future relamping or other maintenance,
apply copper grease to the threads of all screws being fitted for retention of bezels, grills or other top plates or retaining
rings. Copper grease resists degradation due to heat and protects against difficulty in removing screws, particularly where
stainless steel screws are fitted with aluminium parts. It may also be used on screw threads of screw-off bezels or glare
shields. Ensure surplus is cleaned off with a solvent to prevent staining in use.
| Colour/Finish: | Powder Coated Green blends well in lawns |
|---|---|
| IP Rating: | IP67 |
| Construction: | Front bezel is attached to tubular aluminium body. 1m cable via rear entry cable gland |
| Input Voltage: | 12v |
| Lamp Type: | MR16 20w or 50w halogen lamps or MR16 warm white L.E.D. lamps include 3w or 5w; 50,000 life and low energy consumption make them a popular option |
| Installation: | The plastic sleeve is built into the wall during construction or retrofitted into a hole cut with a coring bit: the light pushes into the tube, where it is held firmly in place by an O-ring. Connect input cable to cable from transformer using T9962 cable joint or T9963 cable splice kit. |
12v Installation
All exterior lighting products on our website have an IP rating which is explained further in our design ideas section but
in simple terms the IP rating is appropriate to each light fitting and its intended application and is therefore fit
for purpose. Water ingress is the enemy for outdoor lighting and the products supplied are only as good as the installation
as the weakest point is always cable joints. All joints must be made 100% water tight and this can be done using IP68
inline connectors, waterproof junction boxes which are then filled with a resin or gel mix. All joints where possible
should be made above ground for easy access and reduced water ingress. When installing ground buried lights adequate
drainage systems should be put in place especially
in clay based soil areas. Also mains cable should be SWA rubber and not PVC.





























Reviews
There are no reviews yet.