Eyelite 240v IP54 Garden Step Light – G9 Aged Silver Finish
This solid brass Eyelite Steplight with aged silver finish is a smart 240v surface mount garden light, ideal for
lighting stepped areas. It can be mounted on walls next to steps, or on the steps themselves. The ‘eye lid’ design results
in all light shining downwards, without glare, which makes it perfect for the function of lighting steps.
The fitting comes in either 240v or 12v – code EYE12P-S and also in Solid Brass with a Rustic Bronze finish. codes EYE240 and EYE12-P
The Eyelite garden step lights are smart 240v surface mount garden lights ideal for lighting walls next to steps,
or on the steps themselves. The ‘eye lid’ design results in all light shining downwards, without glare, which makes it perfect
for the function of lighting steps. A mirrored reflector inside the step light ensures all light is emitted outwards with
a frosted glass lens diffusing the light evenly. The Eyelite garden step lights are both robust and stylish. They have a
high IP rating of IP54, and 3 external screws to firmly secure the front to the back. This step light has a G9 lamp holder. An
LED G9 capsule is recommended however there is limited space inside and only the 2w LED G9 will currently fit.
Lamp Colour (Kelvins)
The colour of a lamp is defined as a measurement called kelvins. A standard GLS incandescent bulb in the home would be
2,700 kelvins which is in the warm colour spectrum and a lamp with 5,000 kelvins would be at the very cold white
spectrum.
Installation – 240v See Instructions & Data Sheets Tab
Choosing the style of a product is only part of the equation you must also think of where that product will be used and how
it will be installed. All exterior lighting products on our web site have an IP rating appropriate to each light fitting
and its intended application and is therefore fit for purpose. Water ingress is the enemy for outdoor lighting and the
products supplied are only as good as the installation. The weakest point is always cable joints. All joints must be
made 100% watertight and this can be done using IP68 cable connectors and/or waterproof junction boxes which are then
filled with a re-enterable liquid gel mix. All joints where possible should be made above ground for easy access and
reduced water ingress. When installing ground buried lights adequate drainage systems should be put in place especially
in clay-based soil areas. If possible, use ground surface spike lights rather than a buried light. Mains 240v cable
will have less joints than a low voltage installation but care must be taken with the cable runs. Cabling should be Rubber
Butyl and not PVC. PVC leads to capillary action over time especially with UV degradation.
All exterior lights must be installed by a certified NIC EIC electrician and should be signed off by an electrician with
Part P certification. There are a selection of waterproof jointing kits and boxes available on this web site.























Reviews
There are no reviews yet.