DOWNUNDER OUT S EL – Anthracite Warm White 3000k – 25 Lm 220-240v IP55 – 1.7w

DOWNUNDER OUT S EL – Anthracite warm white 3000k – 25 lm 220-240v IP55 – 1.7w

Very modern contemporary styled mains warm white LED recessed wall light. This outdoor recessed low level wall light can
be used around low level perimeter walls, staircases or as a step light. Easy to install due to its built in warm white LED
lamp and mains 220v – 240v supply. The light fitting is designed to throw the light down and forward and with the main lamp
source set high in the fitting there is no glare created. LED lamps are cool to touch and safe around children they also
have long life span and very ECO friendly due to their low running and maintenance cost’s. This wall light is available in white as well code number 233601 and 40 lumens.

Lamp colour ( Kelvins )

Choosing the style of a product is only part of the equation you must also think of where that product will be used and how
it will be installed. All exterior lighting products on our web site have an IP rating appropriate to each light fitting
and its intended application and is therefore fit for purpose. Water ingress is the enemy for outdoor lighting and the
products supplied are only as good as the installation. The weakest point is always cable joints. All joints must be
made 100% watertight and this can be done using IP68 cable connectors and/or waterproof junction boxes which are then
filled with a re-enterable liquid gel mix. All joints where possible should be made above ground for easy access and
reduced water ingress. When installing ground buried lights adequate drainage systems should be put in place especially
in clay-based soil areas. If possible, use ground surface spike lights rather than a buried light.  Mains 240v cable
will have less joints than a low voltage installation but care must be taken with the cable runs. Cabling should be Rubber
Butyl and not PVC. PVC leads to capillary action over time especially with UV degradation.

All exterior lights must be installed by a certified NIC EIC electrician and should be signed off by an electrician with
Part P certification. There are a selection of waterproof jointing kits and boxes available on this web site.