Downunder OUT L Warm White, 3,000k LED, Wall Brick Light, Mains 220 – 240v 155 Lumens, IP55

Downunder, OUT L warm white, 3,000 kelvin, LED, wall brick light, Mains 220-240v, 155 lumens,
white powder coat, IP55

 Not suitable for coastal areas. Due to the powder coated finish.

The LED in the luminaire cannot be replaced, it may however, be replaced by the manufacturer or a service technician authorised
by them.     

                                                                                       Lamp colour ( Kelvins )

Choosing the style of a product is only part of the equation you must also think of where that product will be used and how
it will be installed. All exterior lighting products on our web site have an IP rating appropriate to each light fitting
and its intended application and is therefore fit for purpose. Water ingress is the enemy for outdoor lighting and the
products supplied are only as good as the installation. The weakest point is always cable joints. All joints must be
made 100% watertight and this can be done using IP68 cable connectors and/or waterproof junction boxes which are then
filled with a re-enterable liquid gel mix. All joints where possible should be made above ground for easy access and
reduced water ingress. When installing ground buried lights adequate drainage systems should be put in place especially
in clay-based soil areas. If possible, use ground surface spike lights rather than a buried light.  Mains 240v cable
will have less joints than a low voltage installation but care must be taken with the cable runs. Cabling should be Rubber
Butyl and not PVC. PVC leads to capillary action over time especially with UV degradation.

All exterior lights must be installed by a certified NIC EIC electrician and should be signed off by an electrician with
Part P certification. There are a selection of waterproof jointing kits and boxes available on this web site.

<