Big Plot Module 220 – 240v 5.5w 3000k 460 Lumens Silver Grey Aluminium Casing IP67 Ground Light

Big Plot Module 220 – 240v 5.5w 3000k 460 Lumens Silver Grey Aluminium Casing IP67 Ground Light

Back by popular demand is the Big plot pathway light. This mains 220 – 240v fitting consists of a 5.5w warm white 3000k
circular cluster LED module which sits on an aluminium silver grey powder coated base. The diameter is 12.4cm and the height is 1.6cm. 
The IP rating is IP67.

The module is non replaceable but should have a life expectancy of up to 35,000 hours. The module has a 180 degree beam angle
and give out 460 lumens. which equates to a 40w standard incandescent lamp.

The module uses a variety of covers which you need to order separately. 

The 2 slot covers are code numbers 1001254 in Stainless Steel.  1001252 in Silver Grey and 1001262 in Anthracite.

The 4 slot covers are code numbers 1001255 in Stainless Steel. 1001253 in Silver Grey and 1001263 in Anthracite.

The module can be connected directly to a 220 – 240v mains voltage supply.

The installation cannot go into soft soil and the cabling should be protected with in ground cable ducting.

Installation 220 – 240v – See Instructions & Data Sheets Tab

All exterior lighting products on our website have an IP rating which is explained further in our Technical Help/Products
section but in simple terms the IP rating is appropriate to each light fitting and its intended application and is therefore
fit for purpose. Water ingress is the enemy for outdoor lighting and the products supplied are only as good as the installation
as the weakest point is always cable joints. All joints must be made 100% watertight and this can be done using IP68
inline connectors, waterproof junction boxes which are then filled with a resin or gel mix. All joints where possible
should be made above ground for easy access and reduced water ingress. When installing ground buried lights adequate
drainage systems should be put in place especially in clay based soil areas. 

=”center”>All exterior lights must be installed by a certified NIC EIC electrician and should be signed off
by an electrician with Part P certification. There are a selection of waterproof jointing kits and boxes available on
this web site.